show system restore failures
Use this command to display configuration restoration status after save reload device.
Command Syntax
show system restore failures
Parameters
None
Mode
Exec mode
Applicability
This command was introduced in OcNOS version 5.1.
Example
Configuration restoration successful status information after save reload device:
#show system restore failures
Configuration restore from DB is completed.
Total no. of failed configuration objects = 0
Configuration restoration failure status information after save reload device:
#show system restore failures
Configuration restore from DB is completed.
Total no. of failed configuration objects = 1.
Failed Protocols information :
Protocol Name=ipi-interface, Protocol Id=3 :
Failed configuration object information :
Total no. of failed configuration objects = 1.
Object Name = config, DN = cmlAutoDummy3074=3074,name=eth0,cmlAutoDummy3073=3073 :
Error Information :
Total no. of configuration errors = 1.
ErrorCode = -16946, ErrorMessage = % No such VRF, ErrorXpath = /interfaces/interface[name='eth0']/config.
Last modified date: 10/19/2023