hardware-profile service-queue
Use this command to set the number of service-queue counts to create in hardware.
Use the no form of this command to set the service queue profile to default
Note: Reboot the switch after giving this command for the changes to take effect.
Command Syntax
hardware-profile service-queue (profile1| profile2)
no hardware-profile service-queue
Parameter
profile1
Supports new 4 queue-bundle per service (default)
profile2
Supports new 8 queue-bundle per service
Default
By default, profile1 is enabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
This command is only available on Qumran platforms.
Examples
#configure terminal
(config)#hardware-profile service-queue profile2
(config)#no hardware-profile service-queue
Last modified date: 10/19/2023