Dynamic Host Configuration Protocol Client

OcNOS-SP : System Management Guide : System Management Command Reference : Dynamic Host Configuration Protocol Client

This chapter describes the Dynamic Host Configuration Protocol (DHCP) client commands.

DHCP is used to configure devices that are connected to a network so they can communicate on that network using the Internet Protocol (IP). DHCP is implemented in a client-server model where DHCP clients request configuration data, such as an IP address, a default route, or DNS server addresses from a DHCP server.

This chapter contains these commands:

• feature dhcp

• ip address dhcp

• ip dhcp client request

• ipv6 address dhcp

• ipv6 dhcp address-prefix-length

• ipv6 dhcp client request

• ipv6 dhcp client

• show ipv6 dhcp vendor-opts

Last modified date: 10/19/2023