description
Use this command to assign an description to an interface.
Use the no parameter to remove an interface description.
Command Syntax
description LINE
no description
Parameter
LINE
Interface description. Avoid the special characters “?”, “,”, “>”, “|”, and “=” in the description.
Default
No default value is specified
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
The following example provides information about the connecting router for interface eth1.
Router#configure terminal
Router(config)#interface eth1
Router(config-if)#description Connected to Zenith's fas2/0
Last modified date: 10/19/2023