interface
Use this command to select an interface to configure, and to enter the Interface command mode.
Use the no parameter with this command to remove this configuration.
Command Syntax
interface IFNAME
no interface IFNAME
Parameter
IFNAME
Name of the interface.
Default
No default value is specified
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
This example shows the use of this command to enter the Interface mode (note the change in the prompt).
#configure terminal
(config)#interface eth3
(config-if)#
Last modified date: 10/19/2023