load interval
Use this command to configure the interval for which average traffic rate need to be shown. Intervals can be configured in steps of 30 seconds.
Use the no parameter with this command to set the load interval to its default.
Command Syntax
load-interval <30-300>
no load-interval
Parameter
<30-300>
Load period in multiples of 30 seconds.
Default
By default, load interval is 300 seconds
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface xe1/1
(config-if)#load-interval 30
(config-if)#no load-interval
Last modified date: 10/19/2023