loss-measurement dynamic
This command enables the loss measurement. This command is tied to the delay measurement session already created to measure the delay. In case this command is issued without the delay-measurement command previously issued, an error is returned.
Use the no form of this command should be used to disable the loss measurement.
Command Syntax
loss-measurement dynamic
no loss-measurement dynamic
Parameter
None
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 5.1.
Example
#configure terminal
(config)#interface xe1
(config-if)#loss-measurement dynamic
(config-if)#no loss-measurement dynamic
Last modified date: 10/19/2023