poe-enable
Use this command to enable Power over Ethernet feature for PoE supported interfaces.
Use the no form of this command to disable Power over Ethernet feature on PoE supported interfaces.
Note: Command is supported only for boards which supports PoE interfaces:
Command Syntax
poe-enable
Parameter
None
Default
No default value is specified
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 5.1.
Example
#configure terminal
(config)#interface ge1
(config-if)#poe-enable
(config)#ge1
(config-if)#no poe-enable
Last modified date: 10/19/2023