show interface controller details
Use this command to display the EEPROM details.
Command Syntax
show interface (IFNAME|) controllers (remote)
Parameters
IFNAME
Interface name. If not specified, this command displays details of all connected transceivers.
remote
Interface name
Default
None
Command Mode
Exec mode
Applicability
This command was introduced in OcNOS version 6.2.0
Example
The following command displays detailed information of smart SFP.
OcNOS#show interface controllers remote
Codes: SMF - Single Mode Fiber, MMF - Multi Mode Fiber, FC - Fiber Channel
OM1 - 62.5 Micron MMF [200MHzkm @ 850nm & 500MHzkm @ 1310nm]
OM2 - 50 Micron MMF [500MHzkm @ 850nm & [500MHzkm @ 1310nm]
OM3 - 50 Micron MMF [2000MHz*km @ 850nm], OUI - Vendor ID
OM4 - 50 Micron MMF [4700MHz*km @ 850nm], BR - Bit Rate, CC - Check Code
AOC - Active Optical Cable, ACC - Active Copper Cable, PC - Power Class
CDR - Clock Data Recovery, CLEI - Common Language Equipment Identification
LR - Long Reach, SR - Short Reach, IR - Intermediate Reach
CCA - Copper Cable Attenuation
############################################################
Port Number : 24
Name : WTD
OUI : 0x0 0x1c 0xad
Part No : RTXM330-8921
Serial_Number : ME223702430001
Identifier : SFP/SFP+/SFP28
Ext. Identifier : GBIC/SFP Is Defined By Two-Wire Interface ID Only
Connector Type : LC (Lucent Connector)
Ethernet/Ext-Eth Compliance : 100GBASE-LR4 or 25GBASE-LR
SONET Compliance :
Infiniband Compliance :
ESCON Compliance :
FCLink Length :
FC Technology :
FC Transmission Media :
FC Speed :
SFP+ Cable Technology :
Length SMF : 10 (Kilometers)
Length SMF : 100 (X 100 Meters)
Length OM1 : 0 (X 10 Meters)
Length OM2 : 0 (X 10 Meters)
Length OM3 : 0 (X 10 Meters)
Length OM4 : 0 (X 10 Meters)
Revision Level : V01
Wavelength : 1269nm
Manufacturing Date : 220809 (yymmddvv, v=vendor specific)
Encoding Algorithm : 64B/66B
CC : 0x25
CC Ext. : 0x68
Nominal BR : 255 (X 100 MBd)
Max BR : 103
Min BR : 0
Options Implemented : Power Level 3
Paging
Internal Re-Timer Or CDR
Cooled Laser Trasnmitter
Power Level 2
RATE_SELECT
TX_DISABLE
TX_FAULT
Rx Loss Of Signal (LOS)
DDM Support : Yes
Last modified date: 10/19/2023