logging remote facility
Use this command to set a syslog servers facility.
OcNOS supports logging messages to one or more remote syslog servers. but the same facility is used for all the servers.
Use the no form of this command to use the default facility value, which is local7.
Note: Only one facility is supported for all protocol modules across all the configured logging servers.
Command Syntax
logging remote facility (local0|local1|local2|local3|local4|local5|local6|local7|user)
no logging remote facility
Parameters
facility
Entity logging the message (user defined); if not specified, the default is local7
local0
Local0 entity
local1
Local1 entity
local2
Local2 entity
local3
Local3 entity
local4
Local4 entity
local5
Local5 entity
local6
Local6 entity
local7
Local7 entity (default)
user
User entity
Default
If not specified, the default facility is local7.
Command Mode
Configure mode
Applicability
This command was introduced in OcNOS version 4.1.
Examples
#configure terminal
(config)#logging remote facility local 6
(config)#no logging remote facility
Last modified date: 10/19/2023