nvo vxlan access-if
Use this command to map a complete interface or a VLAN or VLAN range on an interface to identify the tenant traffic and to enter NVO access interface mode.
The command nvo vxlan access-if port <if_name> default accepts all tagged, double tagged and untagged traffic received on the mapped physical port.
Use the no form of this command to unmap an interface or a VLAN.
Note: When a VxLAN access interface configured as a port VLAN as VLAN-range or port as default, then arp-cache and nd-cache should be disabled and only VNID with inner-vid-enable is mapped.
Note: Inner-vid-enable is one-to-one mapping. VNID is mapped to only on one access-port.
Note: VLAN Range not allowed to be configured for VXLAN stacked access-port.
Command Syntax
nvo vxlan access-if (port IFNAME (| default) | port-vlan IFNAME VLAN_RANGE (| inner-vlan <2-4094>))
no nvo vxlan access-if (port IFNAME | port-vlan IFNAME VLAN_RANGE(| inner-vlan <2-4094>))
Parameters
port
A physical port.
IFNAME
Interface name (Physical/Static lag/Dynamic lag)
default
Default access interface
port-vlan
The physical port on which VLANs are configured
IFNAME
Interface name (Physical/Static lag/Dynamic lag)
VLAN_RANGE
Configure VLANId or VLAN-Range for outer VLAN
Inner-vlan
Inner-VLAN id
<2-4094>
VLAN id
Default
By default, the nvo vxlan access-if option is port VLAN ID.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3 and VLAN_RANGE option is introduced in OcNOS version 5.0. This command is not available on Qumran2 devices.
Example
#configure terminal
(config)#nvo vxlan access-if port-vlan xe1 2-10
(config-nvo-acc-if)#exit
#configure terminal
(config)#nvo vxlan access-if port xe1
(config-nvo-acc-if)#exit
#configure terminal
(config)#nvo vxlan access-if port xe1 default
(config-nvo-acc-if)#exit
#configure terminal
(config)#nvo vxlan access-if port-vlan xe1 2 inner-vlan 10
(config-nvo-acc-if)#exit
Last modified date: 10/20/2023