nvo vxlan vtep-ip-global
Use this command to set the source IP address of the VxLAN tunnels.
Use the no form of this command to remove the source IP address of the VxLAN tunnels.
You must enable VXLAN with the
nvo vxlan command before you give this command.
Command Syntax
nvo vxlan vtep-ip-global A.B.C.D
no nvo vxlan vtep-ip-global A.B.C.D
Parameters
A.B.C.D
Source VTEP IP address of the global configuration
Default
No default value is specified for nvo vxlan vtep-ip-global command.
Command Mode
NVO mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
(config-nvo)#nvo vxlan vtep-ip-global 10.10.11.1
Last modified date: 10/20/2023