show ethernet cfm maintenance-points local mep
Use this command to display information about the Maintenance End Points (MEPs) on a local interface.
Command Syntax
show ethernet cfm maintenance-points local (mep) (interface IFNAME|)(domain DOMAIN_NAME)(ma-name MA_NAME)
Parameters
IFNAME
Interface name. This token can be used only for Down MEPs on L2 bridge.
DOMAIN_NAME
Enter the name of the domain.
MA_NAME
Maintenance association name.
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced in OcNOS DC version 4.2.
Example
#show ethernet cfm maintenance-point local mep xe2
MPID Dir Lvl VLAN CC-Stat HW-Status CC-Intvl MAC-Address Def Port MD Name
--------------------------------------------------------------------------------
100 Dn 7 10 Enable Installed 100 ms 3c2c.99f0.b0c1 F xe2 12345
#show ethernet cfm maintenance-points local mep domain 12345 ma-name
MPID Dir Lvl VLAN CC-Stat HW-Status CC-Intvl MAC-Address Def Port MD Name
--------------------------------------------------------------------------------
100 Dn 7 10 Enable Installed 100 ms 3c2c.99f0.b0c1 F xe2 12345
Table 3 explains the output fields.
Table 3: show ethernet cfm maintenance-points local mep
Field | Description |
|---|
MPID | MEP identifier |
Dir | Up MEP or Down MEP |
Lvl | MD level |
Vlan | VLAN identifier |
CC-Stat | Whether continuity checking (CC) is enabled or disabled |
HW-Status | Installed or pending to install in hardware |
CC-Intvl | CCM Interval |
MAC-Address | MAC address |
Def | Defect present |
Port | CFM interface |
MD Name | MD name |
Last modified date: 07-13-2023