show mpls
Use this command to display MPLS data.
Command Syntax
show mpls
Parameters
None
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
The following subsection displays a variety of show mpls commands.
#show mpls
Minimum label configured: 16
Maximum label configured: 1048575
Per label-space information:
Label-space 0 is using minimum label: 16 and maximum label: 1048575
Label-space 2342 is using minimum label: 556 and maximum label: 1048575
Custom ingress TTL configured: none
Custom egress TTL configured: none
Log message detail: none
Admin group detail: none
Packets dropped IP:115167, dropped MPLS:0 sent to IP:490943, labeled:0, switch
d:0
MPLS Differentiated Services Supported Classes data:
CLASS DSCP_value
be 000000
MPLS Differentiated Services CLASS to EXP mapping data:
CLASS DSCP_value EXP_value
be 000000 0
#
Table 1 explains the show command output fields.
Table 1: show mpls output field
Field | Description |
|---|
Packets dropped IP | Displays the number of packets dropped over the internet protocol. |
Dropped MPLS | Displays the number of packets dropped over the MPLS. |
Sent to IP | Displays the number of packets transmitted to the internet protocol. |
Labeled | Number of labeled packets in the interface. The MPLS-labeled packets are switched after a label lookup/switch instead of a lookup into the IP table. Labels of pop-and-forward mpls tunnel: P—Pop labels. D—Delegation labels. |
Switch | Type of switching on the links needed for the MPLS. |
Class | Creates a class map to be used for matching traffic to a specified class, and enters class-map configuration mode. |
DSCP Value | The value of the DSCP and DSCP classifier is used for routing Layer 3 packets. |
EXP value | Sets the value of the MPLS EXP field on all imposed label entries. |
Last modified date: 07-13-2023