lldp-agent
Use this command to create an LLDP agent mode.
Note: This command is not supported in SVLAN, VLAN, and loopback interfaces.
Use the no parameter to remove configured lldp agent mode.
Command Syntax
lldp-agent (non-tpmr-bridge |customer-bridge| )
no lldp-agent (non-tpmr-bridge |customer-bridge| )
Parameters
non-tpmr-bridge
non-tpmr-bridge
customer-bridge
customer-bridge
Default
By default LLDP agent is disabled.
Command Mode
Interface Mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth0
(config-if)#lldp-agent customer-bridge
(if-lldp-agent)#
(if-lldp-agent)#no lldp-agent customer-bridge
(if-lldp-agent)#exit
(config-if)#
Last modified date: 07/13/2023