Alarm | Description |
|---|---|
CMM_DDM_MONITOR_CURRENT | Transceiver Bias Current crossed the threshold limit |
CMM_DDM_MONITOR_FREQ | Transceiver Frequency crossed the threshold limit |
CMM_DDM_MONITOR_RxPOWER | Transceiver Rx Power crossed the threshold limit |
CMM_DDM_MONITOR_TEC | Transceiver Thermoelectric Cooler fault |
CMM_DDM_MONITOR_TEMP | Transceiver Temperature crossed the threshold limit |
CMM_DDM_MONITOR_TxPOWER | Transceiver TX Power crossed the threshold limit |
CMM_DDM_MONITOR_VOLT | Transceiver Voltage crossed the threshold limit |
CMM_DDM_MONITOR_WAVE | Transceiver Wavelength crossed the threshold limit |
CMM_FAN_CTRL | Fan insertion, removal, speed, or fault condition alarm |
CMM_MONITOR_CPU | CPU load average crossed the threshold limit |
CMM_MONITOR_CPU_CORE | CPU core usage crossed the threshold limit |
CMM_MONITOR_DISK_READ_ACTIVITY | Disk read activity crossed the threshold limit |
CMM_MONITOR_DISK_REMAIN_LIFE | Disk remaining life crossed the threshold limit |
CMM_MONITOR_DISK_WRITE_ACTIVITY | Disk write activity crossed the threshold limit |
CMM_MONITOR_PSU_POWER | Power supply unit insertion, removal, or fault condition |
CMM_MONITOR_PSU_IIN | Power supply unit input current crossed the threshold limit |
CMM_MONITOR_PSU_IOUT | Power supply unit output current crossed the threshold limit |
CMM_MONITOR_PSU_PIN | Power supply unit input power crossed the threshold limit |
CMM_MONITOR_PSU_POUT | Power supply unit output power crossed the threshold limit |
CMM_MONITOR_PSU_PRESENCE | Power supply unit is present |
CMM_MONITOR_PSU_TEMP1 | Power supply unit temperature 1 crossed the threshold limit |
CMM_MONITOR_PSU_TEMP2 | Power supply unit temperature 2 crossed the threshold limit |
CMM_MONITOR_PSU_VIN | Power supply unit input voltage crossed the threshold limit |
CMM_MONITOR_PSU_VOUT | Power supply unit output voltage crossed the threshold limit |
CMM_MONITOR_RAM | RAM memory usage crossed the threshold limit |
CMM_MONITOR_SDCARD | Hard-disk usage crossed the threshold limit or fault condition |
CMM_MONITOR_TEMP | Temperature sensor crossed the threshold limit |
CMM_TAI_CD_ALARM | RX lane current chromatic dispersion crossed the threshold limit |
CMM_TAI_CD_CLEAR | RX lane current chromatic dispersion recovered from the threshold |
CMM_TAI_Q_MARGIN_ALARM | Network RX Q-margin over PM interval value crossed threshold limit |
CMM_TAI_Q_MARGIN_CLEAR | Network RX Q-margin over PM interval value recovered from the threshold |
CMM_TAI_RX_LOS | RX-Loss-Of-Signal alarm Detected |
CMM_TAI_RX_LOS_CLEAR | RX-Loss-Of-Signal alarm Cleared |
CMM_TAI_SNR_ALARM | Network lane0 current Signal-to-Noise Ratio crossed threshold limit |
CMM_TAI_SNR_CLEAR | Network lane0 current Signal-to-Noise Ratio recovered from the threshold |
CMM_TRANSCEIVER | Transceiver on fault condition |
IFMGR_IF_DOWN | Interface state down |
IFMGR_IF_UP | Interface state up |
CMM_MONITOR_FAN | FAN monitoring - crossed the threshold limit |
CMM_MONITOR_CURRENT | Current crossed the threshold limit |
CMM_MONITOR_VOLTAGE | Voltage crossed the threshold limit |