SyncE Show Commands
This chapter describes the Synchronous Ethernet show commands:
show debugging synce
Use this command to display debugging of Ethernet Synchronization.
Command Syntax
show debugging synce
Parameters
NoneOcNOS version 6.2.0
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced in OcNOS version 6.3.0.
Example
#debug synce all
#show debugging synce
SyncE debugging status:
SyncE events debugging is on
SyncE receive debugging is on
SyncE transmit debugging is on
show synce stats
Use this command to display Ethernet Synchronization statistics.
Note: Show esmc counters changed to show synce stats.
Command Syntax
show synce stats
Parameters
None
Command Mode
Privileged Exec mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#show synce stats
Interface Name Status ESMC Received ESMC Sent
_______________________________________________________
xe47 OK 1________________1
xe48 OK 5________________2
show synce details
Use this command to display details of the clock most recently selected by the Clock Selection Algorithm (CSA).
Command Syntax
show synce details
Parameters
None
Command Mode
Privileged Exec mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#show synce details
Equipment Clock : EEC-option1
Interface Name : eth9
ESMC Status : OK
Is-selected-Source : YES
QL : QL_PRC
SyncE Clock State : Locked
DPLL Clock State : Locked
Synce State Duration : 00:03:26
Selected-Clk-Src-ID : 256
show synce input-sources
Use this command to display details of all interfaces that are configured as Synchronous Ethernet input sources.
Command Syntax
show synce input-sources
Parameters
None
Command Mode
Privileged Exec mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#show synce input-sources
Interface Name : xe1
ESMC Status : OK
Is-selected-Source : YES
QL Configured : QL_PRC
QL received in ESMC : QL_PRC
Operational QL : QL_PRC
Priority : 1
Hold-off(ms) : 300
Wait-to-restore(mins) : 5
Signal Fail : No
External Commands : None
Clock-source-ID : 256
WTR Timer Running : No
Hold-off Timer Running : No
show synce output-sources
Use this command to display details of all interfaces that are configured as Synchronous Ethernet output sources.
Command Syntax
show synce output-sources
Parameters
None
Command Mode
Privileged Exec mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#show synce output-sources
Interface Name : eth6
Link State : Up
QL Configured : QL_PRC
QL Operational : QL_DNU