quality-level
Use this command to set the quality level (QL) for the timing source.
Use the no form of this command unconfigure quality-level on a port.
Command Syntax
quality-level QL_VAL
no quality-level
Parameters
QL_VAL
Quality level. The quality level you can specify depends on setting of the
synce-interface command. See ITU-T Rec. G.781 for details.
QL_PRC
Primary Reference Clock
QL_SSU_A
Types I or V slave clock
QL_SSU_B
Type VI slave clock
QL_SEC
SDH Equipment Clock
QL_DNU
Do not use this signal for synchronization
QL_STU
Synchronized – traceability unknown
QL_ST2
Traceable to stratum 2
QL_ST3E
Traceable to stratum 3E
QL_SMC
Traceable to SONET clock self timed
QL_PROV
Provisionable by the network operator
Command Mode
Interface Synchronous Ethernet mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
(config)#interface eth1
(config-if)#synce
(config-if-synce)#quality-level QL_PRC
Last modified date: 06/30/2023