learning enable
Use this command to enable learning on a particular attachment circuit (AC) interface.
Use the
learning disable (Interface VPLS Mode) command to disable learning on a particular AC interface.
Note: This command enables MAC learning only on that AC interface.
Command Syntax
learning enable
Parameter
None
Default
By default, learning enable is enabled
Command Mode
Interface VPLS mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth0
(config-if)#mpls-vpls vpls1 service-template st1
(config-if-vpls)#learning enable
(config-if-vpls)#exit
Last modified date: 10/17/2023