OcNOS-SP : Layer 3 Guide : Open Shortest Path First Command Reference : OSPFv3 Commands : show ipv6 ospf virtual-links
show ipv6 ospf virtual-links
Use this command to display information about OSPFv3 virtual-links.
Command Syntax
show ipv6 ospf virtual-links
show ipv6 ospf WORD virtual-links
Parameters
WORD
Tag value to use as a “match” value for controlling redistribution via route maps.
Command Mode
Privileged Exec mode and Exec Mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 5.6.7.8 is up
Transit area 0.0.0.1 via interface eth0, instance ID 0
Local address 3ffe:1234:1::1/128
Remote address 3ffe:5678:3::1/128
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:01
Adjacency state Up
 
If Hello Suppression is enabled
RTR_B#show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 4.4.4.4 is up
Transit area 0.0.0.1 via interface eth2, instance ID 0
Hello suppression Enabled
DoNotAge LSA allowed
Local address 2002::1/128
Remote address 2002::2/128
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in inactive
Adajcency state Full
RTR_B#
RTR_B#
Table 3-57 explains the fields for each ospf virtual-links entry.
 
Table 3-57: show ipv6 ospf virtual-links output details
Field
Description
Virtual Link
Virtual link name, the router ID to which it is connected, and the state of the link.
Transit area
Transit area ID, the interface it uses, and its instance ID – an Instance ID should default to 0. It is only necessary to assign a value other than 0 on those links that will contain multiple separate communities of OSPF routers.
Local address
The local IPV6 address and subnet mask.
Remote address
The remote IPv6 address and subnet mask.
Transmit Delay
The delay, in seconds, between link-state transmits. This value must be the same for all nodes on the network. The range is 1 to 65535. The default is 1. The state is point-to-point.
Timer intervals configured
The configured values in seconds of the following timers: Hello, Dead, Wait, Retransmit.
Hello due in
A countdown timer that indicates when the next Hello packet should arrive.
Adjacency State
Whether the adjacency state is either up or down.
Last modified date: 10/16/2023