OcNOS-SP : Multicast Guide : Protocol Independent Multicasting Command Reference : PIMv6 Commands : show ipv6 pim neighbor
show ipv6 pim neighbor
Use this command to display IPv6 PIM neighbor information.
Command Syntax
show ipv6 pim neighbor (detail|)
show ipv6 pim neighbor IFNAME (detail|)
show ipv6 pim neighbor IFNAME X:X::X:X (detail|)
show ipv6 pim (vrf NAME|) neighbor (detail|)
show ipv6 pim (vrf NAME|) neighbor IFNAME (detail|)
show ipv6 pim (vrf NAME|) neighbor IFNAME X:X::X:X (detail|)
Parameters
vrf
The VPN routing/forwarding instance
NAME
Specify the name of the VPN routing/forwarding instance
IFNAME
Name of the interface
X:X::X:X
IPv6 address of the neighbor interface
detail
Display detailed information for a PIM neighbor
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#show ipv6 pim neighbor detail
rtr6# show ipv6 pim neighbor detail
Nbr fe80::5054:ff:fe21:5e56 (eth2)
Expires in 83 seconds, uptime 01:37:14
Holdtime: 105 secs, T-bit: off, Lan delay: 1, Override interval: 3
DR priority: 1, Gen ID: 321289676,
Interface ID: Router-ID: 4.4.4.4 Local-ID: 4,
ECMP REDIRECT enabled
Secondary addresses:
3ffe:192:168:1::150
Nbr fe80::5054:ff:fe29:f7f3 (eth2)
Expires in 79 seconds, uptime 01:37:15
Holdtime: 105 secs, T-bit: off, Lan delay: 1, Override interval: 3
DR priority: 1, Gen ID: 847253139,
Interface ID: Router-ID: 2.2.2.2 Local-ID: 4,
ECMP REDIRECT enabled
Secondary addresses:
3ffe:192:168:1::149
 
 
Table 2-30 explains the fields for each pim entry.
Note: For show ipv6 pim (vrf NAME|) neighbor detail command:
• Output shall contain ‘Bidirectional Forwarding Detection is enabled’ in case PIMv6 BFD detection is enabled for this neighbor.
Table 2-30: show ipv6 pim Neighbor
Entry
Description
Interface name
As stated
Address
The IPv6 address of the interface.
DR
The IPv6 address of the Designated Router (DR).
Hello period
When PIM is enabled on an interface or a router first starts, the Hello Timer of that interface is set to a random value between 0 and Triggered_Hello_Delay. This prevents synchronization of Hello messages if multiple routers are powered on simultaneously. After the initial randomized interval, Hello messages MUST be sent every Hello_Period seconds. The Hello Timer should not be reset except when it expires.
Next Hello
The time period before the next Hello is sent.
Triggered Hello period
A per-interface Hello Timer (HT(I)) is used to trigger sending Hello messages on each active interface. When PIM is enabled on an interface or a router first starts, the Hello Timer of that interface is set to a random value between 0 and Triggered_Hello_Delay.
Propagation delay
The Propagation Delay field of the LAN Prune Delay option (if present) in the Hello message.
ECMP REDIRECT
Whether Equal-Cost Multiple-Path (ECMP) is allowed and on which bundle.
Secondary address
As stated.
Last modified date: 10/20/2023