forwarding profile
Use this command to configure different forwarding profiles in hardware.
Use the no form of this command to set the forwarding profile to default.
Note: It is required to save the configuration and reboot the board for the new forwarding profile to come into effect in the hardware.
Use
show forwarding profile limit to verify the configured profile.
Command Syntax
forwarding profile (kaps (profile-one | profile-two)) | (elk-tcam (profile-one | profile-two | profile-three | custom-profile))
no forwarding profile (kaps) | (elk-tcam (custom-profile))
Parameters
For details about these profiles, see
show forwarding profile limit.
kaps
Internal KBP routing table
profile-one
KAPS profile one
profile-two
KAPS profile two
elk-tcam
External TCAM routing table
profile-one
external TCAM profile one
profile-two
external TCAM profile two
profile-three
external TCAM profile three
custom-profile
external TCAM custom profile
< 10-90>
percent of ipv4 routes
< 10-90>
percent of ipv6 routes
Default
The default forwarding profile are as below
Table 34-98:
Is ELK-TCAM present | KAPS | ELK-TCAM |
|---|
Yes | profile-two | profile-one |
No | profile-one | N/A |
Note:
1. elk-tcam profiles are supported only on hardware models which have external TCAM for routing.
2. forwarding profile-three is applicable on hardware model Agema AGC7648A.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version SP 1.0. The no version of the command was introduced in OcNOS version 5.0.
Examples
#configure terminal
(config)# forwarding profile elk-tcam profile-one
(config)# no forwarding profile elk-tcam
Last modified date: 10/19/2023