show interface counters error-stats

OcNOS-SP : System Management Guide : System Management Command Reference : Interface Commands : show interface counters error-stats

Use this command to display the ingress error traffic counters on the interface.

Command Syntax

show interface (IFNAME|) counters error-stats

Parameter

IFNAME

Interface name.

Command Mode

Exec mode and Privileged Exec mode

Applicability

This command was introduced before OcNOS version 1.3.

Example

#show interface xe1/1 counters error-stats

+----------+-------------+--------+----------+---------+-----------+---------+

+----------+-------------+--------+----------+---------+-----------+---------+

xe1/1 120 8 100 10 2 0

Table 21-54 explains the columns in the output.

Table 21-54: error traffic counters
Column	Description	Causes
Interface	Name of the interface	Point of interconnection in network.
Total errors	Total number of all types of errors	Number of errors in network.
Bad CRC	Number of packets received by the port from the network, where the packets have no CRC or a bad CRC.	Packet data modified making the CRC invalid.
Undersize	Total number of packets received that are less than 64 octets long (which exclude framing bits, but include the FCS) and have a good FCS value.	Bad frame generated by the connected device.
Oversize	Number of packets received by the port from the network, where the packets were more than maximum transmission unit size.	Faulty hardware, dot1q, or ISL trunking configuration issues.
Fragments	Total number of frames whose length is less than 64 octets (which exclude framing bits, but which include the FCS) and have a bad FCS value.	Ports are configured at half-duplex. Change the setting to full-duplex.
Jabbers	Total number of frames whose length is more than the maximum MTU size. (which exclude framing bits, but which include FCS) and have a bad FCS value.	Ports are configured at half-duplex. Change the setting to full-duplex.

Last modified date: 10/19/2023