OcNOS-SP : System Management Guide : System Management Command Reference : Network Time Protocol : show ntp peer-status
show ntp peer-status
Use this command to display the peers for which the server is maintaining state along with a summary of that state.
Command Syntax
show ntp peer-status
Parameters
None
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#sh ntp peer-status
Total peers : 1
* - selected for sync, + - peer mode(active),
- - peer mode(passive), = - polled in client mode,
x - source false ticker
remote refid st t when poll reach delay offset jitter
==============================================================================
*216.239.35.4 .GOOG. 1 u 24 64 377 38.485 0.149 0.053
#
 
 
Table 14-24 explains the output fields.
 
Table 14-24: show ntp peer-status fields
Entry
Description
Total peers
Number of servers and peers configured.
* - selected for sync, + - peer mode (active),
- - peer mode (passive), = - polled in client mode x - source false ticker
 
Fate of this peer in the clock selection process.
Remote
Address of the remote peer.
refid
Reference ID (0.0.0.0 for an unknown reference ID).
st
The stratum of the remote peer (a stratum of 16 indicated remote peer is unsynchronized).
t
Type of peer (local, unicast, multicast and broadcast).
when
Time the last packet was received.
poll
The polling interval (seconds).
reach
The reachability register (octal).
delay
Current estimated delay in seconds.
offset
Current estimated offset in seconds.
jitter
Current dispersion of the peer in seconds.
 
 
Last modified date: 10/19/2023