OcNOS-SP : Layer 3 Guide : Two-Way Active Measurement Protocol Command Reference : TWAMP Commands : twamp-light control
twamp-light control
Use this command to initialize the TWAMP light Control or Sender Session.
Use the no form of this command to un-initialize and to remove the configured TWAMP light control configurations.
Command Syntax
twamp-light control
no twamp-light control
Parameters
NA
Command Mode
Configuration mode
Applicability
This command was introduced before OcNOS version 3.0.
Example
#configure terminal
(config)#twamp-light control
 
 
Last modified date: 10/16/2023