TWAMP Commands

OcNOS-SP : Layer 3 Guide : Two-Way Active Measurement Protocol Command Reference : TWAMP Commands

TWAMP Commands

This chapter describes the commands used to manage the Two-Way Active Measurement Protocol (TWAMP).

Note: The implementation of TWAMP measurement relies on software timestamps collected at the application layer. The measured packet path in this case is longer than the actual link path and thus the timestamps used in the delay measurement are less accurate.

• control-admin-state

• reflector-admin-state

• reflector-name

• show debugging twamp

• show running-config twamp

• show twamp server sessions information

• show twamp statistics

• show twamp server status

• test-session-name (Deprecated)

• twamp-light control

• twamp-light reflector

• twamp server