show nvo vxlan tunnel
Use this command to view the source, destination, and status of the VxLAN tunnel entries.
Command Syntax
show nvo vxlan tunnel
Parameters
None
Command Mode
Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
The following is a sample output of the show nvo vxlan tunnel command.
#show nvo vxlan tunnel
VXLAN Network tunnel Entries
Source Destination Status Up/Down Update
====================================================
1.1.1.1 2.2.2.2 Installed 00:00:20 00:00:20
Total number of entries are 1
Table 1-12 explains the output fields.
Table 1-12: VxLAN tunnel fields
Field | Description |
|---|
Source | Tunnel source IP address. |
Destination | Tunnel destination IP address. |
Status | Installed: Tunnel Installed in the hardware and operating. Resolved: Tunnel destination IP is reachable, but VxLAN tunnel not installed in hardware. Therefore, not operating. Unresolved: Tunnel destination IP not reachable because L3 route is down. |
Up/Down | When the tunnel came up or went down |
Update | When the tunnel was last updated |
Total number of entries | The total number of entries listed. |
Last modified date: 10/20/2023