OcNOS-SP : Multi-Protocol Label Switching Guide : Multi-Protocol Label Switching Command Reference : EVPN MPLS Commands : evpn mpls multihoming enable
evpn mpls multihoming enable
Use this command to enable evpn mpls multihoming
Use the no form of this command to disable evpn mpls multihoming.
Note: Node will have to be restarted for this to be applicable. If there are some nodes in topology which have multi-homed CEs, then the nodes which do not have multi-homed CEs should also enable multihoming, so that they can load share traffic to the multi-homed CEs.
Note: Before enabling multi-homing, configure the hardware-profiles with the hardware-profile filter evpn-mpls-mh commands.
Command Syntax
evpn mpls multihoming enable
no evpn mpls multihoming enable
Parameters
None
Default
By default evpn mpls multihoming is disabled.
Command Mode
Configure mode
Applicability
This command was introduced in OcNOS version 4.0.
Example
#configure terminal
#(config)# evpn mpls multihoming enable
#(config)# exit
 
 
Last modified date: 10/17/2023