OcNOS-SP : Multi-Protocol Label Switching Guide : Multi-Protocol Label Switching Command Reference : Virtual Private LAN Service Commands : exit-signaling
exit-signaling
Use this command to exit the VPLS signaling configuration mode, and start signaling. To configure signaling with LDP, see the signaling ldp command. Other VPLS signaling configuration commands include show mpls vpls, show mpls vpls, vpls-vc, vpls-ac-group, and vpls-peer.
Note: It is critical to give this command after all VPLS signaling configurations are complete, otherwise signaling does not start.
Command Syntax
exit-signaling
Parameters
None
Default
No default value is specified
Command Mode
VPLS Signaling mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
# configure terminal
(config)#mpls vpls test 100
(config-vpls)#signaling ldp
(config-vpls-sig)#exit-signaling
 
Last modified date: 10/17/2023